Tie rod end bearings

Rod ends for carwash use in tilt arms, wobbler arms and any moving joint.

Tie rod ends for automatic carwash equipment, automotive, race cars, go carts and much more.

tie rod ends for swivel joints in automatic carwash equipment.
Tie rod ends are often used in various car wash equipment, blow dryers, race cars and trucks.  Most automatic carwash equipment incorporates them  wherever arms tilt, rock or move.  A "wobbler" arm or tilt arm rod end commonly have the carbon rod ends when the car wash equipment is set up from the manufacturer. We have been using the new Igubal rod ends for over two years with great success. Customers enjoy not having to grease the rod end bearing, the loss of squeaking noises and the cost savings. 

We carry both!

Igubal® Grease Free
Self Aligning, maintenance free bearings made of  high polymers.
Dry running - No lubrication needed
Insensitive to dirt and dust
Corrosion Free
Highly chemical resistant
Compensates for shaft misalignment
Bearings are slightly oversized for OD and ID on purpose before pressfit.  After pressfit in to housing bore, they will compress to ID 

Low Carbon Steel
Surface is hardened for  wear resistance
Dichromate-treated for corrosion resistance
Bearing should be kept lubricated 
Rod ends for carwash equipment especially rollover machines that use wobblers.  

 

 

 

Send mail to clearstreamco@aol.com with questions / comments about this web site.
www.clearstreamco
Copyright © 2000 Clear Stream Co., Inc
Last modified: July 20, 2005

Warranty and Return Policy

Terms of Use

 Clear Stream Co Privacy Policy