|
|
|
||
|
Tie Rod Ends |
|||
|
|
|||
 |
 |
||
| Tie rod ends are used often in various car wash
equipment, blow dryers, race cars and trucks. Most automatic carwash equipment
incorporates them where ever arms tilt, rock or
move. A "wobbler" arm or tilt arm rod end commonly have the carbon rod ends when the car wash equipment is set up from the
manufacturer. We have been using the new Igubal rod ends for over two years with great success. Customers enjoy not having to grease the
rod end bearing, the loss of squeaking noises and the cost savings.
We carry both! | |||
| Igubal® Oil Free | Low Carbon Steel | Self Aligning, maintenance free bearings made of high polymers. | Surface is hardened for wear resistance |
| Dry running - No lubrication needed | Surface is hardened for wear resistance | ||
| Insensitive to dirt and dust | Dichromate-treated for corrosion resistance | ||
| Corrosion Free | Bearing should be kept lubricated | ||
| Highly chemical resistant | Rod ends for carwash equipment especially
rollover machines that use wobblers.
|
||
| Compensates for shaft misalignment | |||
| Bearings are slightly oversized for OD and ID on purpose before pressfit. After pressfit in to housing bore, they will compress to ID | |||
|
| |||
|
Send mail to clearstreamco@aol.com with questions / comments about this web site. | |||
| Clear Stream Co Privacy Policy | |||
