pneumatic air dryer water mist separator

1-800-441-7897

Air Dryer, Mist separator

NAF2000 air dryer mist separator for pneumatics. Zinc die cast body with zinc die cast bowl. Clear Polycarbonate bowl is available but due to problems we have seen with it cracking, we have chosen to equip our air dryers with zinc bowls.

Proper Installation: Flush piping before installation.

Poly carbonate bowls may fail if exposed to synthetic oils, thinner solvents, trichlorethylene, kerosene or other aromatic hydrocarbons. The poly carbonate bowl carries no warranties. When used in above atmospheres, please use the metal bowl.

Auto Drain - Float type (normally open) drain line should be 5/16" (8mm) or more should be less than 16.5 ft (5m). Be sure NOT to have any upward turns in drain line which would prevent drainage.

Unsuitable for flow below 3.5scfm(100Ne/min)

Minimum operation pressure 15 psi (0.1 MPa)

Install vertically

Maintenance - Filter element to be changed after 1 year or when pressure drop of 15psi (0.1MPa) is reached.